gure 9
gure 10
(Patented)
We recommend changing these lters after three
bag replacements or canister emptying. The LCD
monitor will indicate when to change the lters.
These indications are provided by an electronic
timing board only as a reference guide.
To do so:
1. Unlatch the opening on the carbon lter case
and gently ip it upward (gure 9).
2. Remove the used lter, and discard (gure 10).
3. Insert the new lter. When doing so, please
ensure that the arrow printed on the lter itself
points outwards. (gure 11).
4. Close casing opening, and latch.
Part number : TDFILHEC2
gure 11
17
Maintenance
Motor
Please note that our motors do not require lubrication. Each motor contains two
carbon brushes that will wear normally, and may eventually require replacement.
For warranty purposes, replacement should be done by an authorized dealer.
Brush life is affected by hours of use, frequency of start-ups and shut-downs,
humidity, altitude, and temperature. In order to avoid damage to the unit’s motor,
brushes should be replaced before they are completely worn-out. We therefore
recommend that you have your unit and motors inspected by an authorized dealer
every 5-6 years.
Carbon Dust Filter
To Next Page
Loading...