gure 13
gure 12
gure 14
A
B
19
Maintenance
Maintenance
Change the bag when the one in place is full.
Frequency will depend on the use of the unit.
1. To access the bag, unlatch the two clips and
remove the dust receptacle (gure 12).
2. Remove the used bag and seal bag opening
(adhesive seal provided on each bag).
Discard used bag.
3. Install the new bag, ensuring the tabs on
the bag adaptor are aligned with the slots in
the bag collar (gure 13).
4. Ensure adequate sealing by inserting bag as
far as the retention ring.(gure14-A).Rotate
bag 20°
(gure 14 - B) to ensure tabs on
bag adaptor are no longer aligned with the
slots in the bag collar.
5. Replace dust receptacle and seal by
latching both clips.
Use only genuine Trovac replacement bags.
Failure to do so could void the warranty on
your vacuum unit.
Use with bag
retention
ring
tabs on bag
adaptator
To Next Page
Loading...