ITRON Axonic - User Manual

EN
DE
FR
PL
IT
CZ
SLO
RU
CN
User guide ................................................................................................... 2
Montage- und Bedienungsanleitung ....................................................... 10
Manuel d’utilisation ...................................................................................18
Instrukcja obsługi ....................................................................................... 26
Manuale utente ........................................................................................ 34
Návod k obsluze ........................................................................................42
Navodila za montažo in uporabo ............................................................ 50
РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ ...................................................... 58
安装操作说明 ........................................................................................... 66
Axonic
USER GUIDE

ITRON Axonic Specifications

General

Brand	ITRON
Model	Axonic
Category	Measuring Instruments
Language	English

Summary

1- DELIVERY AXONIC

2- GENERAL INDICATIONS

2.1 - Advise concerning safety

Safety advice for installation and operation, emphasizing qualified personnel, high temperatures, pressures, and voltages.

2.2 - CE marks and protective classes

Outlines CE compliance, environmental classes, temperature limits, IP rating, and proper disposal of electronic waste.

2.3 - Further important indications

Key instructions on handling, cable placement, thermal insulation, calibration, cleaning, and local regulations.

3- MOUNTING THE FLOW METER

3.1 - Operating conditions, materials and dimensions

Specifies operating parameters, materials in contact with water, and pressure loss characteristics for different pipe sizes.

3.2 - Mounting instructions

3.3 - Gaskets

Table listing gasket types, references, and dimensions for different nominal diameters (DN) and pressure ratings (PN).

4 - ELECTRICAL CONNECTION AND POWER SUPPLY

4.1 - Connecting the flow meter to integrator unit

Guidance on connecting the Axonic flow meter to an integrator unit, covering pulse outputs and ensuring pulse weight compatibility.

4.2 - Specification of connection to integrator

4.3 - Characteristic of pulse outputs (A+B)

4.4 - Power supply

4.5 - Optional connecting AXONIC with Pulse-Box to integrator unit (optional power supply)

5-FUNCTION CONTROL OF AXONIC

Function control at the calculator:

Guidance on performing functional control and plausibility checks using the calculator's flow rate and volume index.

Putting into operation:

Confirms that after a successful functional test, the Axonic is ready for use and final technical inspection.