Need help?Do you have a question about the ITRON 100W and is the answer not in the manual?
General| Brand | ITRON |
|---|---|
| Model | 100W |
| Category | Measuring Instruments |
| Language | English |
Defines conventions used, including part numbers, hypertext links, notes, cautions, and warnings.
Explains the installation instructions for the ERT modules and their mounting options.
Outlines the chapter structure and the information covered in each section.
Lists other relevant Itron documentation for further reference.
Describes Last Good Read (LGR) Flag and Extended Tamper Flag behavior.
Lists various ERT module models with their descriptions and Itron part numbers.
Explains the ISM enhanced security features for authentication and encryption.
Details how installers enable security using an Itron programming device.
Provides information on the expected battery life of the ERT modules.
Describes the different transmission modes for the ERT modules.
Explains the three standard operating modes for the 100W/100W+ module.
Details the four standard operating modes for the 100WP/100WP+ module.
Explains the Geo Mode for improving network coverage for hard-to-read meters.
Provides steps to initialize the 100W/100W+ module using a handheld computer.
Outlines the automatic start-up process for 100W/100W+ encoder modules.
Details the programming requirements for the 100WP/100WP+ module using FDM.
Describes the start-up procedure for 100WP/100WP+ pulser modules after programming.
Explains how to use the inline connector for ERT module and meter register connection.
Details connecting the ERT module to the meter register using 5-foot or 20-inch cables.
Instructions for connecting the ERT module to a remote meter register.
Information on using a 25-foot inline connector extension cable assembly.
Steps to verify ERT module operation and consumption readings.
Lists various mounting methods for the ERT modules.
Details the accessory kits required for different mounting types.
Instructions for installing modules with integral connectors and securing them.
Step-by-step guide for mounting the ERT module on a 1/2-inch rod.
Lists tools and hardware needed for rod mount installation.
Instructions for mounting the ERT module on a flat vertical surface.
Lists tools and hardware needed for wall mount installation.
Describes installing the ERT module in a pit lid without a pre-drilled hole.
Steps for mounting the ERT module using its base tab onto a flat surface.
Lists tools and hardware needed for base mount installation.
Details installing the ERT module using a shelf mount adapter in a pit lid slot.
Instructions for mounting the ERT module in a pit lid with a pre-drilled hole.
To Next Page
