CENTRON Meter Technical Reference Guide I-1
A
ADC 3-2, 3-4
AEP barcode 7-2
AEP test codes 8-4
alternate display mode 5-3
Alternate mode annunciator 5-5
Alternate Mode Magnetic Reed Switch 8-6
analog to digital converter (ADC) 3-2
annunciator 2-2, 5-5, 8-2–8-3, G-1
Alternate mode 5-5
disk emulator 8-4
EOI 5-6
kWh 5-6
Test 5-4
test mode 5-5
antenna
RF
6-2, 7-2
Application Specific Integrated Circuit (ASIC) 3-2
ASIC 3-2–3-3
automatic demand reset 5-8
B
barcode
AEP
7-2
LAN address 7-2
base 1-2
base metrology 3-1
battery 1-4, 5-23
life 5-23
baud G-1
billing quantities 5-7
Binary Phase Shift Keyed (BPSK) modulation 7-2
blank display 8-8, 8-10
block demand 5-15, 5-22
block interval 5-21
board-to-board connector 2-3, 2-5–2-6, 4-1
BPSK 7-2
button
test mode
2-2, 5-4
C
calendar schedule 5-15–5-16
calibration 3-3
Cellnet RF technology
C1SC
7-1
Cellnet Shooter 7-4
CENTRON developer’s kit 3-3
circuit board 2-3
metrology 1-3, 6-5
register module 2-1
clock circuit 1-4
Clock error 8-6
clock register 4-1
communication
optical port
5-1
communication problem 8-9
communications rate
default
2-3
comparator 8-3
connector
board-to-board
2-3, 2-5–2-6, 4-1
continuous cumulative demand 5-22
controls and indicators 5-2
counter
power removal
6-5
tamper 5-28
cover 2-2, 5-27
configurations 1-5
inner 2-6
See also inner cover and outer cover
CRC
7-1
Crystal Time synchronization 2-2
cumulative demand 5-22
current interval demand 5-3
current season register 5-9, 5-16
current/potential terminals 2-2
Cyclic Redundancy Checks (CRC) 7-1
cyclometer 4-1
D
daily schedule 5-16
Daylight Savings Time (DST) 5-16
demand calculation 5-21
demand module 5-5
demand register 5-8
demand reset 2-7, 5-15, 8-9
automatic 5-8
demand reset button 5-2, 5-27
demand reset switch 5-15
detent register 4-2
disk emulation annunciator 8-4
display
duration
G-1
display item 5-6
display modes 5-3
DST 5-16
E
EEPROM 5-17, 5-23, G-1
EEPROM error 8-7
electronic detent 5-2, 5-20, 6-3, G-1
electronic load indicator 5-5, 6-3
Index
To Next Page
Loading...
