21
Meter support training
EM512 TYPE 700 JV1 Installation procedure
The following steps forms part of the installation of an EM512 TYPE 700 JV1 meter:
Installation of the EM512 TYPE 700 JV1 meter
First power up
Commissioning instructions
It is vital that the prepayment meter is installed correctly as this could determine the meter functionality and
lifespan. Please follow the prescribed procedures carefully!
General
The meter has a standard mounting footprint. This affords:
Easy installation, independent of the supply authority, by an electrical contractor.
Easy meter exchange, i.e. the possibility of selection from a range of energy dispensers made by
different manufacturers.
When selecting a suitable position for the EM512 TYPE 700 JV1 meter, consider the following:
Legal requirements of the relevant statutory authorities
Internal procedures stipulated by the supply authority
Security (indoors or outdoors) against tampering
General safety in terms of possible electric shock, fire, etc.
For safety reasons, and also to avoid damage to the dispenser, positions the dispenser at least 1m
away from a water tap
To prevent damage, the dispenser should not be installed above a stove or heater
Avoid damage to the dispenser from doors opening
Installation height should be 1.5 to 1.8m above floor level
Mobility of residents and furniture should not be impeded
Future positioning of e.g. kitchen cupboards in a newly constructed home should be kept in mind
General accessibility is important
Meter Handling
The EM512 TYPE 700 JV1 product range has been tested extensively to verify its toughness to external
factors. Please avoid the following actions:
Do not drop meter during installation;
Do not try to clean meter in water;
Do not use sharp objects to cut the plastic covering the meter as this can damage the cover of the
meter;
Do not pack meters with face facing the floor, as this would scratch the surface of the cover;
Do not slide meters on any surface with it’s face facing downwards;
Do not throw a meter;
Do not store meters in damp enclosure;
Do not use meter as a hammering tool;
Do not attempt to open the meter;
Do not apply any additional or external voltages to the meter other than what is specified by the
supplier.
To Next Page
Loading...
Need help?
General
