ITW Dynatec
D SERIES V6 DCL ASU Manuals
LCD Programming Page 5-1
Revised 10/14
DynaControl CONTROLLER, V.6.00 and Up
DynaControl (DCL) V6 LCD Interface
DynaControl V6 controller technology is avail able as a liquid crystal display (LCD), which allows an
instant overview of temperature zone and pump status, and with a combination Input Wheel/
Enter Knob to facilitate fast programming. The LCD HMI is the standard controller for the D Series
ASUs.
In General
Press the Return button to return to the Overview Screen (seen on next page).
This controller utilizes the graphics (indicating YES or ON or selected) and (indicating NO
or OFF or not‐selected).
When there is no operator activity on a screen for approximately 30 seconds, the controller will
automatically return to the Overvie w Screen.
LCD
Input Wheel/ Press Knob to Enter
Chapter 5, Section 1
PROGRAMMING INSTRUCTIONS, V6 LCD FOR D SERIES ASUs
Return
Adhesive Application Systems
V6
Adhesive Application Systems
DynaControl
To Next Page
Loading...