Removing Collected Water
Collected water can be removed in the following ways:
1. When the water reservoir is full, remove and empty it.
2. Continuous draining: water can be automatically emptied into a floor drain by attaching the unit to a
water hose with a female threaded end (not included).
a. Remove the plastic cover from the drain outlet of the unit and set aside.
b. Remove the water reservoir and insert the hose through the drain outlet of the unit, pressing it
securely into the connector on the front of the unit.
c. Tighten the adapter and the unit with two screws (not included).
d. Install the female threaded end of the water hose into the adapter, then lead the water hose to
the floor drain or a suitable drainage facility.
Error Codes
The following codes may appear on the LED display.
AS: humidity sensor error
ES: temperature sensor error
P2: the reservoir is full or not positioned correctly
If there is an error, follow the steps below:
1. Turn off the unit
2. Check for any obstructions
3. Restart the unit. If the malfunction is still present, turn off the unit and unplug the power cord.
4. If the error persists, contact the manufacturer, its service agents or a similar qualified person
for service.
Care and Maintenance
• Always turn the dehumidifier off and unplug before cleaning.
• The water reservoir should be washed with fresh water every few weeks.
• The air filter should be washed with clean water at least every 30 days.
• When storing the unit:
• After turning off the unit, wait one day before emptying the reservoir
• Clean the main unit, reservoir, and air filter
• Wrap the cord and bundle it with a band
• Cover the unit with a plastic bag
• Store the unit upright in a dry, well-ventilated place
Water hose
Female
threaded
end
Drain hose
subassembly
Connector
Drain hose
Plastic cover
To Next Page
Loading...
Need help?
General
