14
Basic functions (at customer level 1)
Heating and extra hot water
Press Heat to come to the short cut to the heat settings. These displays
are then available.
House heating settings in areas 0 to 10. See more detailed
description in Heat Settings chapter.
Fine adjustment settings in areas -10 to +10. See more
detailed description in Heat Settings chapter.
Here you can set the heat in areas 0 to 10 if you use an extra
heat curve with a mixing valve.
Here you set the fine adjustment of the mixing valve curve
in –10°C to 10°C.
If a room sensor is connected you can set the required room
temperature here. At customer level 2 you can set how
much you want the sensor to affect the heating system.
You can temporarily increase the hot water temperature
with the electric water heater here. The heat pump first
increases it to around 50° and then the electric water heater
to around 65°. The electric heater starts again at 60° and
increases the temperature to 65° in set time. The area is 1-
48 hours and when the set time has passed, the normal
operation is resumed.
Temperatures
Press “Menu” to come to the main menu. Where you can also
carry out heat settings and see the temperatures. These
displays are then available.
The radiator temperature settings you make in the short cut
to Heat you can also make in line 1 and hot water setting in
line 2.
In line 3 you can see all the temperatures where sensors are
connected.
With
extra
sensor
only
With
extra
sensor
only
With
extra
sensor
only
Opera-
ting
mode A
only
Extra DHW:
1hr 20hrs 48hrs
Return Adjust
Room temperature
10° 20° 30°
Return Adjust
Mix. valve fine-tune
-10° 0,0° 10°
Return Adjust
Mix. valve incr/decr
0 4 10
Return Adjust
Temp. fine-tune
-10° 0,0° 10°
Return Adjust
Temp. incr. / decr.
0 4 10
Return Adjust
Main menu
Monitor all
temperatures 3
Return Select
Main menu
Indoor temperature
settings 1
Return Select
Rego600 K1
020312 12.00.00 Ti
Heat Info Menu
To Next Page
Loading...
Need help?
General