Approved Installation Manual for the Experimental Report No 104
EDM-350 Page 23 of 46 Rev A
Engine Data Management System Date 7-10-2021
3. Tap USER when you see ‘Do you want to restore user table?’ (Note: tapping FACTORY
causes the fuel table stored on the Key Card to over-write any previous user entries in the fuel table.
Use FACTORY if you want to start from the original factory default).
4. Tap TANK to select the next active tank and repeat previous step. Continue until all tanks ‘points’ have
been set.
5. Tap TABLE. You see ‘Fuel Table Data’ ( White at top of screen) with a table. You may change any of
the fuel levels in the left column except for empty. You will enter the readings taken previously on paper
into the right column.
6. Tap/hold STEP to select the cell you want to edit. Tap EDIT to change the value. Tap or hold Modify to
change digit. Tap digit to change another part of the number.
7. Tap SAVE to record it. Follow the on-screen menus to edit the value. Repeat previous step until all
tanks data have been entered.
8. You see ‘Save fuel tank data?’. Answer SAVE to store all final data values or CANCEL to return to
table editing. To complete the process, tap SAVE a second time.
To Next Page
Loading...
Need help?
General
