For Your Safe Flight Page 9
• When an alarm is displayed, tapping the STEP button will temporarily
delete that alarm from appearing for the next ten minutes.
• When an alarm is displayed, holding the STEP button until the word OFF
appears will delete that alarm from appearing for the remainder of the
flight.
LF Button
Located on the lower right side near the instrument face.
• In Automatic or Manual modes, tapping the LF button will
change to the LeanFind mode.
• In Automatic or Manual modes holding the LF button for
three seconds will toggle between Percentage and Normalize
views.
• In the LF mode holding the LF button after peak EGT is
found will display peak EGT.
• In the LF mode tapping the LF button will mark a data
record in long term memory and display will flash SNAP.
Secondary functions of the LF button include:
• In the pilot programming procedure, holding or tapping the LF button is
used to increment or decrement parameter values and toggle between Yes
and No answers to questions.
STEP and LF Buttons
• Holding both the STEP and LF buttons simultaneously for
five seconds changes to the pilot programming procedure.
• Holding both the STEP and LF buttons simultaneously for
five seconds after entering LeanFind mode but before
beginning to lean will toggle between leaning “rich of peak”
and “lean of peak.”
• Tapping both the STEP and LF buttons simultaneously in
Manual mode toggles to include or exclude the displayed
parameter from the Automatic mode. It has no affect on the
displayed parameters in the Manual mode.
To Next Page
Loading...
Need help?
General
