For Your Safe Flight Page 33
Parameter Start Up Sequence with Fuel Flow Option
The first column indicates what position the select switch must be in to
display that particular parameter. T is EGT, F is FF and A is ALL.
Select
Switch
Parameter
Description Example Comments
T, A
Voltage, System Bus
I4.2
BAT
BATTERY VOLTAGE
T, A
Outside Air
Temperature
8I
OAT
°F or °C
T, A
Induction Air
Temperature
I25
IAT
Out of intercooler
T, A
Compressor
Discharge
Temperature
300
CDT
Into intercooler
T, A
Carburetor
Temperature
-22
CRB
Not available when CDT is
installed
T, A
Difference between
hottest and coldest
EGT
80
DIF
Dot indicates most widely
deviating cylinder
T,A,F
RPM
2450
RPM
RPM
T,A,F
MAP
23. I
MAP
Manifold pressure
F, A
Fuel Remaining
37.2
REM
In gallons, liters or pounds or
kilograms
F, A
Fuel required to
next GPS WPT or
Destination
25.9
REQ
Present with GPS interface
Valid signal and way point
F, A
Fuel Reserve at next
GPS WPT or
Destination
I I.3
RES
Present with GPS interface
Valid signal and way point
F, A
Nautical Miles per
Gal
I3.0
MPG
Present with GPS interface and
valid signal or MPK, MPL, MPP
F, A
Time to Empty
02.45
H.M.
Hours. Minutes Remaining at
current fuel burn
F, A
Fuel Flow Rate
I3.5
GPH
Or KPH, LPH , PPH
F, A
Total Fuel Used
38
USD
SINCE LAST REFUELING OR
TRIP TOTAL.
To Next Page
Loading...
Need help?
General
