Page 46 Engine Data Management
3. Tap or hold the LF button to change flashing digit: I 9.00
4. Tap STEP button for next digit: I 9.00
5. Tap or hold the LF button to change flashing digit: I 8.00
6. Tap STEP button for next digit: I8.00
7. Repeat items 5 and 6 for the remaining two digits.
8. Hold STEP and LF buttons simultaneously for five seconds to exit.
Accumulate Total—Trip Total
Select “No” if you wish to display total fuel used since the last time you
informed the EDM that the aircraft was refueled. Select “Yes” to display
total fuel used for an extended trip with multiple fuel stops. This
selection affects only the USD parameter.
GPS-C Comm settings
The GPS-C setting selects the format of the fuel data output of the EDM.
See “Setting GPS-C Fuel Flow Communications Format” on page 50.
Section 13 - Programming Long Term Data Memory
If you haven’t already done so, start the pilot programming procedure,
simultaneously hold the STEP and LF buttons for five seconds. You will
see the word PROGRAM for two seconds. To change the date, time and
user id for the Long Term Data Memory, tap the STEP button until the
display shows DUMP? N. Next, simultaneously hold the STEP and LF
buttons for five seconds. Then set the date and time as show below:
STEP LF Comments
TIME 2⇒
500
Record time interval, in seconds
MNTH I ⇒
I2
Month
DAY I ⇒
3I
Day
YEAR 80 ⇒
79
Year (note: represents 1980 through 2079)
HOUR OO ⇒
23
24 hour time. We suggest you set Zulu time
MIN OO ⇒
59
THIS ALSO ZEROS THE SECONDS
N----
-
N
I2345
Current Aircraft ID. To change Aircraft ID, hold both
STEP and LF buttons until the first character flashes. LF
selects the first character. STEP moves to the next
To Next Page
Loading...
Need help?
General
