Jabiru 3300 - Page 32

Engine Maintenance Manual
Jabiru Aircraft Pty Ltd
JEM0002-5
Jabiru 2200 & 3300 Aircraft Engines
This document is controlled while it remains on the Jabiru server. Once this no longer applies the document becomes uncontrolled.
ISSUE
1
2
3
4
5
Dated : 2nd June 2015
Issued By: AS
Page: 32 of 103
L:\files\Manuals_For_Products\Engine_Manuals\Engine Maintenance Manual 22 & 33\JEM0002-5.docx
6.7 Equipment:
Access to the following equipment will be required:
 Bench vice with padded jaws
 Calipers: must read up to 180mm
 Degreasing/cleaning system with solvent/solution containment/recycling
 Dial indicator and magnetic stand, vee blocks
 Hand press
 Heat gun or small butane/propane torch with a soft pencil flame
 Micrometer and internal measuring tools, must read up to 100mm
 Multimeter or an ohmmeter
 Spring scale: must read up to 2.5kg in 0.1kg increments
 Thread taps: 1/4", 5/16”, 3/8” UNF and UNC
 Valve seat cutters: 30°, 45° and 60°
 Valve spring compressor, motorcycle type or a ‘G’ clamp with a machined spring cup
6.8 General:
 Brass drifts, punches, rags, soft mallet, hammers
 Greases: molybdenum disulphide, general purpose
 Loctite compounds: 242/243/262 ThreadLocker, 515 Sealant, 620 Retainer, 7471 Cure
Accelerator
 Lubricants: engine oil, Nulon L90
 TorqueSeal brand security marking lacquer or similar, such as coloured nail varnish