9.4 jABRA PRO 920 BASE
The Jabra PRO 920 base meets the following specications.
Dimensions:
118 mm x 76 mm x 29 mm.
Wireless standard:
(CAT - iq) European DECT and U.S. DECT.
Operating environment:
-0˚C to +40˚C; Up to 95% RH non-condensing.
Recharge cradle:
Fits supplied Jabra PRO 900 series headset.
Desk Phone connections:
RJ-11 for handset, RJ-11 for phone body (or headset port), RJ-45 for AUX (for
Jabra Link or GN1000 handset lifter).
Clear Dial Tone switch and microphone volume switch:
Electromechanical switches. Clear dial tone switch and microphone volume
level set manually.
Electronic hookswitch standards:
GN1000, Jabra IQ, DHSG and MSH, and other Jabra DHSG adapters. Each EHS
requires additional cabling and/or equipment available separately. GN1000 is
supported by default and requires no additional conguration.
9.5 PRODUCT DISPOSAL
Please dispose of the headset according to local regulations and recycle when
possible. Do not dispose as household waste. Do not dispose of the headset in
a re as the battery may explode. Batteries may also explode if damaged.
9.6 CERTIFICATIONS AND SAFETY APPROVALS
CE
This product is CE marked according to the provisions of the R & TTE Directive
(99/5/EC). Hereby, GN declares that this product is in compliance with the
essential requirements and other relevant provisions of Directive 1999/5/EC.
For further information, please consult http://www.jabra.com.
Within the EU, this device is intended for use in Austria, Belgium, Cyprus,
Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary,
Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, The Netherlands, United Kingdom, and within EFTA in
Iceland, Norway and Switzerland.
To Next Page
