Tempstar HH Series Technical Manual 7610-002-23-32
Issued: 09/14/2007 Revised: N/A
SECTION 5: PARTS SECTION
STEAM TUB ASSEMBLY (CONTINUED)
30
ITEM QTY DESCRIPTION Mfg. No.
1 1 Tub Weldment 05700-002-63-13
2 1 Rack Assembly 05700-002-01-00
3 2 Bulk Head Plug 04730-609-05-00
4 1 Motor & Pump Assembly See page entitled Wash Motors
5 1 Gasket 05700-111-35-03
6 1 O-ring 05330-400-05-00
7 4 Bolt, Hex 3/8”-16 x 1 1/4" Long 05305-276-10-00
8 1 Lower Wash Manifold Weldment 05700-031-46-00
9 1 Suction Strain Weldment 05700-001-22-23
10 1 Suction Strain Bracket 05700-001-22-24
11 8 Locknut, 1/4"-20 with Nylon Insert 05310-374-02-00
12 1 Strainer Weldment 05700-021-50-07
13 1 Wash Overflow Weldment 05700-001-25-69
* 1 Support, Ball Stop Lift 05700-002-91-55
* 1 Ball Stop Lift 05700-003-07-50
14 1 Overflow Support Bracket 05700-001-27-55
15 1 O-Ring 05330-400-05-00
16 2 Clamp, Hose 1 5/16” to 2 1/4” 04730-719-01-37
17 1 Discharge Hose 05700-011-88-24
18 1 Nipple 05700-021-34-84
19 1 Pump Support Bracket Assembly 05700-002-00-46
20 1 Clamp, Hose 5 5/8" to 6" 04730-011-34-90
21 1 Connector, 1/2” 90° 05975-111-01-00
22 4 Nut, 3/8"-16 S/S Hex 05310-276-01-00
23 4 Lockwasher, 3/8” 05311-276-01-00
24 1 Steam Coil Assembly 05700-002-08-62
25 1 Probe, High Water 06680-200-02-68
26 1 Thermostat, Regulating with Imperial Brass Fitting 06401-003-18-23
27 1 Cover, Wash Heater 05700-031-47-57
28 1 Decal, Warning-Disconnect Power 09905-100-75-93
29 2 Locknut, 10-24 with Nylon Insert 05310-373-01-00
To Next Page
Loading...
