en-9
JACOBSEN G-PLEX III Series: FH & FJ
SAFETY AND OPERATORS MANUAL
4 SPECIFICATIONS
4.1 ENGINE SPECIFICATION
TYPE:TYPE: Kubota 13.2KW @ 3200 RPM,
3 cylinder Diesel engine, 4
stroke, water cooled, 719cc
with 12V electric start.
Model: D722-E3B-RNUK-1
Maximum Speed: 3350 RPM ±50 rpm (No load)
Idle Speed: 1500 RPM ±50 rpm
Oil Sump Capacity:3.2 litres
Firing Order: 1, 2, 3.
Fuel: No. 2-D Diesel fuel (ASTM
D975)
4.1.1 ENGINE SPECIFICATION
TYPE:TYPE: Briggs & Stratton 13.2KW @
3400 RPM, V twin gasoline
engine, 4 stroke, air cooled,
719cc with 12V electric start.
Model: Vanguard 350447 Type 1294
Maximum Speed: 3400 RPM (No load)
Idle Speed: 1500 RPM
Oil Sump Capacity:1.4 litres
Fuel: Unleaded Gasoline Minimum 85
octane
4.2 MACHINE SPECIFICATION
Frame construction:
Heavy duty fabricated steel
chassis.
Transmission:
Variable displacement
hydrostatic pump with high
speed low torque wheel motors.
Cutting unit drive:
Direct drive hydrostatic and reel
drive pumps, bi-directional
hydraulic gear motor with reel
control valve and backlap control
valve.
Speeds:
Cutting: 6 km/h
Transport: 12 kp/h
Reverse: 3 kp/h
Steering: Rear Wheel Steering. Power
Steering, 2.5 turns lock to lock
330mm dia. Steering Wheel
Ground pressure: 1.0 kg/cm
Brakes, Service: Positive hydrostatic braking.
Parking: 152 mm Calliper Disk
Capacities:
Cooling System: 3.8 litres
Fuel Tank: 31 litres
Hydraulic Tank: 18.2 litres
Total System 25.7 litres
Battery: 12 volt, Type 093
Alternator Diesel 40 amp
Gasoline 15 amp
4.3 CUTTING UNIT
Type: Three 559mm wide steerable
floating head.
Reel: 127mm diameter, 7 / 9 / 11
knife.
Rolls: Smooth rear roll, smooth or
grooved front /rear rolls optional.
Bedknife to reel
adjustment: Opposed set screw.
Height of cut
adjustment: Micro-adjusters on front roll.
Height of cut: 2.5mm to 16mm Standard blade
2mm to 16mm Tournament
blade.
To Next Page
Loading...
