en-37
JACOBSEN TR3
SAFETY, OPERATORS & MAINTENANCE MANUAL
8.3 CUTTING UNITS 47114, 47115, 47116
LUBRICATION
Always clean the grease fitting before and after
lubricating.
Lubricate the following with Shell Darina R2 grease.
Apply grease with a manual grease gun and fill slowly
until grease begins to seep out. Do not use
compressed air guns.
For smooth operation of all levers, pivot points and
other friction points that are not shown on the
lubrication chart apply several drops of SAE 30 oil
every 40 hours or as required.
Grease fittings (A Mower Pivot, 3 Fittings) every 50
hours and fittings (J Reel Bearings, 6 Fittings) every
100 hours.
8 MAINTENANCE & LUBRICATION
To Next Page
Loading...
