Pre-Delivery Checklist
Product No. 67043 - Tri-King 1900 Series
Mower _________________________
Check:
❏ Wheel lug torque 65 - 85 ft. lb. (88 - 115 N.m)
❏ Tire pressure should be:
❏ Front 10 - 12 psi (69 - 83 kPa)
❏ Rear 8 - 10 psi (55 - 69 kPa)
❏ ROPS mounting hardware 57 ft. lbs (77 N.m)
❏ Steering nut torque 30 - 40 ft. lb. (41 - 54 N.m)
❏ Traction pedal stop adjustment
❏ Traction does not creep with pedal in neutral
❏ Parking brake adjustment
❏ Operation of all switches
❏ Function of lift-lower pedal
Engine_________________________
Check:
❏ Engine oil level
❏ Engine coolant level
❏ Air cleaner element and connections
❏ Belt adjustment
Cutting Units ___________________
Check:
❏ All hardware securely fastened
❏ Reel end play, there should be none
❏ Front roller bearing adjustment
❏ Rear Unit lift stop orientaition, and lift adjustment
❏ Adjust reel to bedknife,.001” to .003” (.025 - .08 mm)
❏ Adjust cutting height to customers’ requirements
❏ Adjust down pressure springs
Electrical System _______________
Check:
❏ Operator backup system (Section 4.14)
❏ Reel/3WD switch
❏ Neutral start switch
❏ Parking brake switch
❏ Seat switch
❏ Backlap Switch
❏ Panel gauges and warning lights
❏ Mower Limit switch
❏ For pinched or rubbing wires
Hydraulic System _______________
Check:
❏ Hydraulic oil level
❏ For pinched or rubbing hoses
❏ For twisted or crimped hoses
❏ For oil leaks
❏ Pump drive belt adjustment
❏ Reel motor backlap nuts are set to full forward
Miscellaneous__________________
❏ Check for loose or missing hardware
❏ All lubrication points
❏ Examine paint finish; touch up where necessary
❏ Check decals. In place and legible
❏ Make sure Safety & Operation Manual and Parts &
Maintenance Manual are in the pouch
Support ___________________________________________________________
If you encounter any problems while setting up this
mower, contact contact the Jacobsen Customer Care
department.
Jacobsen, A Textron Comany
11108 Quality Drive
Charlotte, NC 28273
800-848-1636
http://www.Jacobsen.com
Problem Description
_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
Distributor _____________________________________________ Inspected ______________________________
Customer _____________________________________________ Date _________________________________