Jacuzzi J - 235 - Programming CLEARRAY System

J-200
11.6 Programming the CLEARRAY (Ultraviolet) Water Purication
System
A. Programming the CLEARRAY System (U) or Corona Discharge
Ozone (O3)
Press and hold the Jets pump 1 (
1
) and Cooler ( ) button at the
same time for 3 seconds to enter the sanitizing system program. The
screen will display one of the two menus below:
CLEARRAY Menu O3 Menu
1. If the LED screen is displaying “U” then pressing the Jets pump
1 will change the sanitizing system from “U” to “O3” and exit the
programming menu. If the LED screen is displaying “O3” then
pressing the Jets pump 1 will change the sanitizing system from “O3”
to “U” and exit the programming menu.
Note: For the O3 option the “=” disables the duration countdown timer.
2. If you do not wish to change the option do not press any buttons and
after 10 seconds the display will return to the main menu.
Note: If the CLEARRAY System has been selected, when the
time allotted has expired (365 days) the display screen will
ash between the water temperature and “blb.” At this time the UV bulb
must be replaced, the quartz tube must be cleaned and the duration
countdown timer needs to be reset.
Press
or
Press
or
30