17.4 Electronic Device Connections and Functions
IMPORTANT:
• If stereo unit is “ON” (blue light is illuminated on the stereo power
button) then press the power button on the remote once.
• If stereo unit is in “Standby” mode (red light is illuminated on the
stereo power button) then press the power button on the remote
once to activate the remote (remote LCD display will read “NO
LINK”). Press the button again to activate the stereo unit (remote
LCD display will read “WELCOME”).
A. Operating the Radio:
1. Turn power “ON” to the stereo unit. Press the power
button on the remote.
2. The LCD screen on the remote will display the following: “Welcome,”
“Load,” “Radio” and the station number, Figure A.
3. You can use the seek button to search for frequencies.
4. You can save up to 3 stations as presets. Follow the steps below to
set a station:
a. Find a station you want to save.
b. Press and hold one of the three preset buttons. The station
preset number (1, 2, or 3) on the display will quickly ash to
conrm the setting. To set the additional two stations, conduct
this step again.
Figure A
Button Device Mode (USB) Radio Mode
3
DIR +
Press the button to change
music folders.
Preset 3: Press to access a pre-
set station.
RANDOM
Press to play songs in a random
order.
Not used
56
To Next Page
Loading...
