Page 16
• The time required for initial heat-up will vary depending on the start-
ing water temperature.
DANGER:
carefully before entering spa!
Decontamination Procedure (Steps 9-15)
Steps 9-15 below are only required when sanitizer levels are unstable
after performing steps 1-6 above. Disregard steps 9-15 below if sanitizer
levels remain stable at 3.0-4.0 Chlorine or 2.0-4.0 Bromine ppm after
performing steps 1-6 above.
CAUTION: Never add Chlorine tablets (Trichlor) to your
spa for any reason! This chemical may damage components
within your spa and void the manufacturer warranty.
Water Fill Volume by Model
Spa Model Approximate Fill Volume
J-460 ......................
J-465 ......................
J-470 ......................
J-480 ......................
10. Leave spa cover open during this step to allow excessive chemical
vapors to exit spa, protecting pillows and p-
pa is indoors, open doors and windows
for proper ventilation.
hour, open all air controls, and place all massage selec-
(right). Note: You will need to press the jets pump
button(s) every 20 minutes since these functions have
an automatic 20 minute time-out that turns them off.
CAUTION: Never leave your spa unattended for any reason
while the cover is open and accessible to small children and
animals!
outlined in section 12.2 (page 43).
To Next Page
Loading...
Need help?
General
