Installation
5. Install the ozone generator according to the manufacturer’s instructions. Several
commercially available ozone generators will fit easily.
6. Attach the ozone delivery tubing (supplied with the ozone generator) between the ozone
generator outlet port and the ozone injector inlet. Form the extra length of tubing into two or
more loops 6”-12” in diameter. Find the bonded clip underneath the hot tub rim near the
control panel area and secure the loops in a maximum height position by attaching the loops
with a tie wrap strap to this clip.
NOTE: If the ozone generator or ozone tubing includes a check valve, make certain it is
correctly oriented and correctly functioning before installation. The check valve should permit
ozone gas flow from the ozone generator to the ozone injector. See Figure 4.
7. Refill the hot tub with water to the fill mark on the skimmer frame. Check for leaks.
8. Plug the ozone generator power cord into the socket labeled “ozone” on the side of the hot
tub electrical cabinet.
9. Turn on the circuit breaker for power to the hot tub system. Test the GFCI for proper
operation.
10. Operate the hot tub and recheck for leaks.
11. Reinstall the plumbing access skirt panels and equipment access skirt panel.
Page 12
FIGURE 3 - MOUNTING BOARD
USE #6 SCREWS
OZONE GENERATOR
MOUNTING BOARD
ELECTRICAL
CABINET
FIGURE 4 - OZONE GENERATOR VINYL TUBING
(NOTE: VERIFY ORIENTATION
OF CHECK VALVES)
ELECTRICAL
CABINET
OZONE
GENERATOR
POWER PLUG
CONNECTION
VINYL TUBE FROM
GENERATOR
INJECTOR
INLET
TO OZONE
GENERATOR
To Next Page
Loading...
