Page 15
Operation
Operating Instructions
Now that the hot tub is in place, you are probably eager to take advantage of its unique
designed-in features - especially the patented hydromassage performance. Besides being a
beautiful addition to your indoor decor or outdoor landscaping, your Jacuzzi Premium spa will
provide you with the ultimate in hot tub pleasure.
Familiarize yourself with the operation of the electronic control pad, as described on the
following pages of this manual. Access under the hot tub (behind the skirts) is not required for
normal operation.
WARNING: Do not turn ON power to the hot tub unless it is filled with water to the
normal water level. Refer to the water line indicator mark on the skimmer frame.
Whenever the power is ON, the system will activate even though no controls are
operated. When there is not sufficient water in the unit with the hot tub’s motor/pump
actuated, the circulation pump and heater could be irreparably damaged. Not heeding
this caution will nullify the warranty. In addition to damaging the unit, operating the hot
tub with insufficient water could cause a fire.
Initial Instructions
Using a Garden hose, fill the hot tub with water to the water line indicator mark on the skimmer
frame.
At the house service panel, turn ON the circuit breaker or switch that controls the electrical
service to your hot tub. Make sure there are no other appliances on that circuit.
Electrical
Your hot tub must be installed in an electrical circuit protected with a Ground Fault Circuit
Interrupter (GFCI)(refer to Electrical Requirements). At initial start-up and before each use
thereafter, with power ON, push the GFCI test button. The reset button should pop out. Push
this button in to reset. If the interrupter fails to operate in this manner, there is a ground
current flowing or a device malfunctioning, indicating the possibility of electrical shock.
DANGER: Turn OFF power and do not use the hot tub until the source of the problem
has been identified and corrected.
To Next Page
Loading...
