Operation
Page 19
Changing Heating Cycles
If you wish to leave the heater OFF during the day, the following procedure can be used to
change the automatic heater operation.
Press . The time of day will be shown. Then press . The SET TIME
message will be shown. Then press . The SET START FILTER 1 message will
be
shown. At this point, each time the program button is pressed, the filter start time, the heater
enable status symbol, and the filter stop time will be indicated on the display. When the filter
start or filter stop times are displayed,
press or to reset the times. When the SET HEAT message is displayed,
press or to set the center display to ON or OFF.
In the ON position, the hot tub will warm to the set temperature. In the OFF position, the
heater, in the economy mode, will not be activated.
To Next Page
Loading...
