Operation
Page 18
Control Panel Operation
Initial Start-up
The hot tub will automatically begin to operate when electrical power is applied. There is no
ON/OFF switch for the hot tub system. At power up, the jet pump will operate for one minute
to clear any trapped air in the plumbing.
The control system is designed so that by simply connecting the hot tub to its properly grounded
power source and pressing the mode button, the hot tub will function properly and safely at
100 F. In this mode, all control panel buttons are completely functional. To use the full
capabilities, it is important to set the time of day.
Setting the Time of Day:
Press then
then or .
After either button is pressed once, hours will advance or decrease automatically in one
minute increments.
Press either or again to stop the display’s time setting cycle.
Filter System Operation
The hot tub is continuously filtered for 24 hours a day. The blower will activate for 30 seconds
periodically to clean out the air channel and the jet pumps will operate for 5-15 minutes
periodically to circulate the water and skim the water surface. The optional ozone generator
also operates continuously. 24 hour circulation may be interrupted if the hot tub water
temperature is above 100 and 2 above the set temperature until the water temperature returns
to the set temperature or below 100. During this over temperature condition, a pump will run
for 15 minutes every three hours to filter and skim the hot tub water.
NOTE: The optional ozone generator will be disabled for 1 hour whenever the jet pump(s),
blower, or light button is pressed.
To Next Page
Loading...
