Page 13
Installation
Preparing the Hot Tub for Filling
1. Remove the plastic sheet covering the spa.
NOTE: Stepping into the hot tub with shoes will scratch the acrylic surface.
2. Remove any packing materials from the hot tub.
3. The filter cartridges are packaged in a plastic bag which MUST be removed before operating
the hot tub. To gain access to the filters, pull open the skimmer/filter door by the handle
located in the middle of the door and remove the skimmer basket and filter.
Front Access Skimmer/Filter
SKIMMER BASKET
WEIR
DOOR
FILTER CARTRIDGE
ROPE LOOP
4. Clean the interior of the hot tub of any remaining construction debris. Remove stubborn
stains, paint, or tar with isopropyl alchohol. A mild liquid dishwashing detergent on a damp
cloth is fine for cleaning off other dirt. Plaster can be removed by scraping with a soft plastic
or wooden edge. Do not use a metal scraper, wire brush, or other metal tools, as they will
damage the hot tub’s surface.
To Next Page
Loading...
