Important Hot Tub Owner Safety Information
Read and Follow ALL Instructions
The spa must be installed with adequate access and water drainage system (refer to Installa-
tion), to drain water away from electrical components.
CAUTION: Do not turn power ON to the hot tub unless it is filled with water to the normal
water level, which is to the water level indicator mark on the skimmer frame. Activating the hot
tub when there is an insufficient amount of water can damage the circulation pump and may
cause a fire.
Hot tubs installed in a 230VAC circuit:
DANGER-RISK OF ELECTRICAL SHOCK
Your hot tub must be equipped with a GFCI at the Main Electrical Panel. At initial start-up
and before each use thereafter with power ON, push the GFCI test button. The reset
button should pop out. Push this button in to reset. If the interrupter fails to operate in this
manner, there is a ground current flowing or a device malfunctioning, indicating the possi-
bility of electrical shock. Turn off power and do not use the hot tub until the source of
the breakdown has been identified and corrected.
Read manufacturer’s safety information provided with all optional equipment.
Page 4
To Next Page
Loading...
Need help?
General