23
Keyboard lock (Virtus™ model only)
To avoid accidentally modifying the set parameters, there is an op-
tion to activate the keyboard lock function.
XTo enable this function, simply press the keys below at the
same time and hold for approximately 3-5 seconds:
~ 3-5”
The message “Loc” appears (followed by the water temperature).
NOTES
The “keyboard lock” function cannot be activated on round dis-
plays.
When the display is locked, the pumps, spotlight, etc. cannot be ac-
tivated; however, the round displays can be used for activating the
various functions.
XTo disable the keyboard lock, simply press these same keys at
the same time for approximately 3-5 seconds (the water tempera-
ture is displayed).
Abnormal operating conditions -
Messages and alarms on the display
Messages or alarms are indicated on the display with the corre-
sponding error code.
You will continue to see the code if the alarm condition persists.
Please refer to the hot tub installation manual for informa-
tion regarding alarm messages.
ROUTINE MAINTENANCE
The person responsible for managing the system is in charge
of cleaning the hydromassage nozzles and jets, as well as
maintaining the lter
XKeep the hot tub covered at all times when not in use. Along
with stopping the water from getting dirty, this helps to avoid
heat loss and evaporation.
XPeriodically clean the hydromassage and suction intakes.
XModel with Jacuzzi® heat pump: consult the relevant manual
for all related routine maintenance work.
CAUTION
Never clean the hot tub with the pump running. Turn o
the main switch rst.
CAUTION
After cleaning, immediately put the aspiration nozzle
grilles back in place. These safety devices must cover the
suction intake in order to reduce the risk of hair or other
body parts getting caught. The intakes must be cleaned
with the bath empty.
Remember to ret all the parts before lling the hot tub
again.
The suction intake grilles must be checked at least once a
week.
QFILTER MAINTENANCE
XPeriodically check the lter; for normal use of the hot tub, it is
advisable to clean the lter at least once a week (clogged lters
cannot keep the water clean; they also compromise proper sys-
tem operation).
XTo clean the lter, regularly run the backwash as indicated on
the pressure gauge on the selector valve. More specically, this
means taking a reading of the pressure shown on the pressure
gauge when the system is started up or at the end of a scheduled
backwash (this value is normally below 1 atm). When this value
increases by 0.2 atm max. compared to the initial value, the lter
needs to be backwashed.
CAUTION: the pumps must be stationary before using
the selector valve.
XStop the pumps and disconnect the power supply to the hot
tub.
XRemove the cap on the selector valve and connect the lter
drain to the pit via a pipe.
To Next Page
Loading...
Need help?
General
