4-3 Power Supply
Power supply
Please verify the local power source before plugging into the power outlet, and use the
individual power socket and original adaptor.
Alternative power supply
1)（9V/400mA）adaptor
2) (6V/4A) internal rechargeable battery
Power Consumption
About 300mW (without backlight)
About 380 mW (with backlight)
Low battery warning
When ― ‖ appears in the upper left corner of the weight window, the battery power requires
recharging. The charge lamp turns green from red when the recharging is completed (which
takes about 8 hours). Disconnect the scale from power supply when it is fully charged. A full
charged battery can operate the scale for approximately 65 hrs with backlight, 80hrs without
backlight.
Note: Battery is to be replaced only by an authorized service dealer .Risk of explosion can
occur if replaced with the wrong type or connected improperly
5. Setting Mode
5-1 Function Setting
1) Press G N/SET key while powering on
Or long press G N/SET key in the weighing mode to enter parameter setting.
2) Press key
/MR or TARE/
to circle the parameters
3) Press key G N/SET to enter the selected parameter.
4) Press key
/MR or TARE/
to circle the items of present parameter.
5) Press key M+/SAVE to save after changing and return to parameters choosing. While
Press key ZERO/ESC to return without saving.
6) Press key ZERO/ESC again to return to weighing mode.
Note: In the parameter setting mode, press the numeric key to choose the parameter
directly.
To Next Page
Loading...
