Jadever SKY User Manual

Electronic Scale
6
↓
Pr Fu
External device
PC/ SH-24
Item 10, Page 7
↓
diV-Z
Display range
Zero0/1/2/3/4/5
Item 11, Page 7
1. When the LCD display shows Count, press the「UNIT」key, the current internal value
will be displayed. Press 「UNIT」to return to LCD display Count.
2. When the LCD display shows unit , press「UNIT」 to enter into unit selection mode,
the screen will show on g or oFF g , “on” means to use the current unit
displayed, “oFF” means not to use the current unit displayed. Press「SMPL」 to switch
between ON and OFF [to use the unit displayed select “on”, if you do not require the
unit displayed select “oFF”]. Press「UNIT」to select from 13 kinds of weighing units,
after selecting the unit required, press「MODE」to return to LCD display unit .
3. When the LCD display shows InitU , press「UNIT」 to enter initial unit selection
mode. LCD display InitU xx X means the initial unit is selected. Press「UNIT」 to
select the unit required, then Press「MODE」to return to LCD display InitU.
4. When the LCD display shows Auto , press「UNIT」 to enter the Auto Power-Off
selection. LCD display XXX X means Auto Power-off selection. Press 「UNIT」 to
select the auto power-off time, then press「MODE」to return to LCD display Auto .
『 Au-no- means No auto power-off, 5- means 5 minutes, 15-means 15 minutes,
30-means 30 minutes, 60-means 60 minutes 』 (in case of instability, the auto power-off
function will not work)
5. When the LCD display shows bAud , press 「UNIT」 to enter the RS-232 Baud
Rate selection. LCD display XXX X represents the RS-232 baud rate. Press
「UNIT」to select the desired RS-232 baud rate, then press「MODE」 to return to LCD
display bAud . 『 2400, 4800, 9600 』
6. When the LCD display shows ZEro , press「UNIT」 to enter auto zero range
selection. LCD display d X X represents the auto zero range. Press「UNIT」to
select the desired auto zero range, then press「MODE」 to return to LCD display
ZEro 。 『 d0, 1, 2, 3, 4, 5 』 (the higher the value is, the wider auto zero range is)
7. When the LCD display shows FiL , press「UNIT」 to enter filter setting mode.
LCD display FiL X X means the filter level. Press「UNIT」 to select the desired
filter level and press「MODE」 to return to LCD display FiL . 『 FiL1, 2, 4, 8 』
(the higher the value is, the higher the filter level is)
8. When the LCD display shows LigH , press「UNIT」to enter backlight setting mode.

Jadever SKY Specifications

General

Brand	Jadever
Model	SKY
Category	Scales
Language	English