Jaga JRT-100TW - A. 0-10 V BMS WITH WATER TEMPERATURE MONITORING; A.1. FACTORY SETTINGS; A.1. FACTORY SETTINGS CONTINUED; A.1. FACTORY SETTINGS ADDITIONAL

EN
43
JAGA NV | BRIZA   JFCC | MANUEL | .. | V..
curve : Speed versus -V control signal
Min
1010
BMS (V)
Max
A.0  10V BMS WITH WATER TEMPERATURE MONITORING
A.. FACTORY SETTINGS
The device is controlled via BMS. The unit starts when there is a -V control signal and the preset water
temperature has been reached.
The unit starts if the water temperature is > °C/ F and the
control signal is -V.
Only with configuration code FCC.BR / FCC.BR!
The unit starts if the water temperature is <  C/ F and the control
signal is -V.
Fan speed in function of the incoming control signal.
Window contact
The window contact is not activated by default and has to be activated /deactivated manually .
Switch on : turn on the DIP switch 
12345678
ON
1
ON
strain relief
POWER 45W
INPUT: 110-240VAC
OUTPUT: 24V
NL
15120045
GND GND GND GNDNTC1 V.H. V.C.0-10V0-10V0-10V +24V
GND 0-10V 24V
GND 24V
GND 24V
+24V RC IN/OUT GND
Tsens 1
CONTROL PANEL
I2CRS485 A/B
CO2PC / RF
THERMOSTATE 1
DIPSWITCH
Tsens 2
Tsens 3
Tsens 4
JAGA
12345678
ON
(230V - 50Hz)
[C]
[B]
GND
0-10 V
0-10 V )(GND /
[I]
[A]
2-pipe
4-pipe
4-pipe