Information about this manual
ADwin
2 ADwin Installation, manual version 2.1, December 2005
Before installation of the ADwin CDROM
An important note:
Please, pay absolutely attention to the order of the installation steps.
This refers especially to the initialization of the hardware.
For installation step 2 choose the suitable chapter for your ADwin system in the
table:
1. Installation or update of the ADwin CDROM: ⇒ chapter 2
2. Installation of the interface drivers (USB,
Ethernet etc.),
Initialization of the hardware,
Functions check.
Pay also attention to the notes for initializa-
tion in your hardware manual.
⇒ one of the chapters
3…9
(see table below)
3. First steps in ADbasic. ⇒ manual ADbasic
4. Introduction to ADbasic programming ⇒ tutorial ADbasic
ADwin system chapter
– Systems with ADlink PC ISA board
– ADwin boards
– ADwin-light boards (not ADwin-light-16)
3: ADwin ISA link interface,
page 5
– ADlink PCI adapter board 4: ADlink PCI adapter,
page 22
– ADpcmcia linkadapter board 5: ADpcmcia adapter,
page 25
– ADwin-light-16 (PCI, EURO, cPCI, EXT)
with USB interface
6: ADwin-light-16 system
with USB interface,
page 34
– ADwin-Gold
• ADwin-Gold-USB
• USB-link-adapter
7: ADwin-Gold system with
USB interface, page 40
– ADwin-Pro modules
• Pro-CPU-T9-USB
• Pro-USB
8: ADwin-Pro module with
USB interface, page 46
– ADwin-light-16
• EURO-ENET
• EXT-ENET
– ADwin-Gold
• ADwin-Gold-ENET
• Ethernet-link-adapter
– ADwin-Pro modules
• Pro-CPU-T9-ENET,
Pro-CPU-T10-ENET
• Pro-ENET
9: ADwin System with Eth-
ernet Interface, page 50
To Next Page
Loading...