Getting Started XT3 User Manual
Janam Technologies LLC Version 1, March 2020 Getting Started 2—5
Turning the Janam XT3 Rugged Touch Computer on
1. Press and hold the Power Key (marked red in its center)
on the top right-hand side of the XT3.
⎯ If the XT3 is being powered on for the first time,
follow the on-screen setup instructions.
⎯ When the XT3 is on, pressing the power button briefly
will suspend operation until it is pushed again.
2. When powered on, an unsecured XT3 will first display the
Android lock screen. It is unlocked by swiping up on the
screen. The lock screen will be replaced with the start
screen. For information about securing the XT3 with a
password or pin code, refer to Chapter 3.
3. When powered on, a secured XT3 will also first display the
Android lock screen. Swipe up to get to the pin code
keypad. Enter your pin code. Once the correct pin code has
been entered and you’ve tapped on the check mark, the
welcome screen with the pin code keypad will be replaced with the start screen. For
information about securing the XT3 with a password or pin code, refer to Chapter 3.
Unsecured: just swipe up Secured: enter pin, then swipe up Both ways get to the start screen
To Next Page
Loading...