Boot ROM inbuilt Menu, self tests, setups, etc 5 - 1
Revision 1 - 07 July
1999 Event 4 TECHNICAL MANUAL
5. Boot ROM inbuilt menu, self tests,
setups, etc
The Boot ROM contains software that can be used to test, setup, and configure the
console. Note that the software is subject to change depending on the boot software
version.
5.1 Entering the Boot Menu
The boot menu is accessed by holding down the “RECORD” button on the keypad
while turning power on. Release the Record button when the opening menu is
displayed in the programmer LCD.
5.2 Menu Usage
Each menu offers a number of options available. The options are selected by pressing
one of the five buttons above the programmer LCD, or press EXIT to return to the
previous menu.
5.3 Boot Menu
The following menu options are available in the opening menu
1. Continue
2. Load FLASH
3. Test
5.3.1 Continue
Use this option to exit the boot menu and continue normal execution into the main
operating software. Use this option if the boot menu has been entered by mistake.
5.3.2 Reload Software
Selecting the Load FLASH option initiates the software reload sequence from diskette.
Ensure you have an Event 4 software diskette with the file “EVENT4.BIN in the drive
and follow the instructions on the LCD. Note that this facility should be used with
caution and it is not recommended that software be reloaded at a critical time, eg. just
before the start of a show.
To Next Page
Loading...
Need help?
General
