Jands Vista L5 User Manual

Usingtheconsolehardware TheSuperPlayback/Programmercontrols

Editor(akaProgrammer)mode
e on screen palettes to adjust setting for
Intensity, Position, Colour, Gobo and Miscellaneous parameters
n
When you select fixtures in the Chooser or Timeline window the hardware
controls can be used instead or th
Programmermode
If the controls are not already in Programming mode press the menu button the
the button labelled ‘IPCG’ to switch into to programmer mode:
This button…
does this…
I /POS Press this
Intensity p
button to put the encoders and lower 6 buttons in
lus Position mode. Pressing it again cycles the
controls through any available parameters or alternate
odes (Angular position and Strobe & Shutter).
m
Col Press this button to put the encoders and lower 6 buttons in
s the controls
through any available parameters or alternate modes (CMY,
RGB, Colour Wheel Colour )
Colour mode (HSV). Pressing it again cycle
Gobo Press this button to put the encoders and lower 6 buttons in
gh
Gobo mode. Pressing it again cycles the controls throu
any available parameters or alternate modes.
VistaUserGuide,Version2 11‐5

Jands Vista L5 Specifications

General

Brand	Jands
Model	Vista L5
Category	DJ Equipment
Language	English