Jandy AquaLink RS - Page 20

Some buttons on
Controller do not
operate (LEDs for
those buttons
don't light).
Replace
Controller PCB.
Replace Power
Center PPD chip.
No
Yes
Yes
Press the
Cancel button
then select
Lockouts and
finally Device to
unlock.
No
Go to the Power
Center and look at
the LED above the
button; is the LED
on?
No
Contact Jandy
for correct PPD.
Press Reset
button on left
side of
Controller;
the second
number and
Revision letter
is that of the
Power Center
PPD chip.
Does the Part #
for PPD match
the model of
AquaLink RS?
See Chart below.
Press button
which does not
operate; does the
display read
"Locked"?
Yes
Model
Description
Part No. of PPD Chips
AquaLink RS16 P & S
AquaLink RS12 P & S
AquaLink RS8 P & S
AquaLink RS6 P & S
AquaLink RS16 P or S
AquaLink RS4 P & S
AquaLink RS12 P or S
Pool and Spa combination
Pool and Spa combination
Pool and Spa combination
Pool and Spa combination
Pool and Spa combination
Pool or Spa only system
Separate Equipment System
7202
7201
6520
6521
6522
7215
7214
AquaLink RS8 P or S
AquaLink RS6 P or S
AquaLink RS4 P or S
AquaLink RS2/14 Dual
AquaLink RS2/10 Dual
AquaLink RS2/6 Dual
Separate Equipment System
Separate Equipment System
Pool or Spa only system
Pool or Spa only system
Pool or Spa only system
Pool or Spa only system
6523
6524
6525
7217
7216
6526
AquaLink
®
RS Troubleshooting
Some Controller Buttons Do Not Operate . . .
18