Jandy Pro Series User Manual (English)

Other manuals for Jandy Pro Series

Installation And Operation Manual21 pages

Installation Instructions2 pages

Owner's Manual20 pages

Quick Start Guide2 pages

Questions and Answers:

S
Susan GonzalezAug 15, 2025
Why are my Jandy Swimming Pool Lighting colored lights out of sync?
- J
  Jordan CrawfordAug 15, 2025
  If your Jandy Swimming Pool Lighting colored lights are out of sync, ensure proper wire connections. You can also try resetting all the lights to white by turning them off for five seconds and then turning them back on.
C
Chad RobertsAug 18, 2025
Why is my Jandy Swimming Pool Lighting blinking?
- T
  Trevor ThomasAug 18, 2025
  If your Jandy Swimming Pool Lighting is blinking, it might be overheating. Make sure the light is fully submerged in water that does not exceed 104F (40C).
J
john64Aug 22, 2025
What to do if there is low water flow in my Jandy Water Filtration System?
- V
  vrobinsonAug 22, 2025
  If you're experiencing low water flow in your Jandy Water Filtration System, start by checking and cleaning the skimmer and pump baskets, as the filter system strainer baskets may be dirty. Inspect all connections between the pool intake and pump for air leaks. Also, check all lines for debris or partially closed valves that could cause restrictions or blockages. Ensure the pool water level is above the pump inlet line. If the pump isn't primed, fill it with water at the basket and replace the lid. If the filter grids need to be cleaned or replaced, follow the instructions to do so.
M
Michelle PatelAug 25, 2025
How to stop dirt returning to the pool from my Jandy Water Filtration System?
- J
  johnstonallisonAug 26, 2025
  If dirt is returning to your pool from your Jandy Water Filtration System, it could be due to a hole in the filter grid fabric, which requires replacing the filter grid. Another possibility is a worn o-ring seal inside the filter, which should be replaced. A cracked manifold can also cause this issue, so replace the manifold assembly.
J
Jerry ShafferAug 28, 2025
How to troubleshoot Jandy Swimming Pool Lighting when all lights fail to illuminate?
- M
  Matthew UnderwoodAug 28, 2025
  If all Jandy Swimming Pool Lighting fails to illuminate, start by checking the 120VAC power supply into the transformer and verify there's a 12VAC output at the transformer. Check or reset the GFCI. Make sure 120 volts has not been used in the installation - if so damage is assured and is NOT WARRANTABLE.