18
1. Plug the branch CTs into the pola-
rized connectors on the Interface
Board, refer to
2. Place the CT on the correct con-
ductor being sure to align the CT
with the correct terminal and brea-
ker conductor skipping empty con-
ductors,
refer to
3. Snap the CT closed around the con-
ductor and make sure latch is lo-
cked,
refer to
INFORMATION
The CT Orientation is not important;
the system will auto correct,
Current Transformer Types
1
2
NOTE
Further information can be found
in the user manual on our homepage
www.janitza.com
3
To Next Page
Loading...
