2
DANGER
HAZARD OF ELECTRIC SHOCK,
EXPLOSION, OR ARC FLASH
· This product must be installed inside a suitable fire and electrical enclosure.
· Follow safe electrical work practices. See NFPA 70E in the USA, or applica-
ble local codes.
· This equipment must only be installed and serviced by qualified electrical
personnel.
· Do not use this product for life or safety applications.
· Do not install this product in hazardous or classified locations.
· Read, understand and follow the instructions before installing this product.
· Turn off all power supplying equipment before working on or inside the
equipment.
· Product may use multiple voltage/power sources. Disconnect ALL sources
before servicing.
· Use a properly rated voltage sensing device to confirm that power is off.
DO NOT depend on this product for voltage indication.
· Current transformer secondaries (current mode) must be shorted or con-
nected to a burden at all times.
· Products rated only for basic insulation must be installed on insulated
conductors.
· Replace all doors, covers and protective devices before powering the
equipment.
· The installer is responsible for conformance to all applicable codes.
· Failure to follow these instructions will result in death or serious injury.
Safety Information
To Next Page
Loading...
Need help?
General
