Janome 2041 - Sewing on Buttons

42
6
A
C
D
E
F
G
H
I
J
K
L
C
3
4
5
2
1
0
2
1
0
4
3
1 2
3
4 5
1 2 3
4 5
z Adjust the stitch width, and turn the handwheel to check
if the needle enters into each hole on the button.
x Lower the foot to hold the button in place.
The holes on the button should align with the slot of the foot.
c A pin can be placed on the foot to form a shank.
Make sure to check if the needle enters into both holes
on the button.
Sew about 10 stitches and cut the needle and bobbin
threads, leaving 20 cm (8") tail.
v Bring the needle thread between the button and fabric
through the holes on the button.
Pull the needle thread to pick bobbin thread up to
the right side of the fabric.
Wind the threads to from a shank and tie them together.
b Raise the feed dog after sewing.
Sewing on Buttons
q Pattern selector: C
w Presser foot: Zigzag foot
e Thread tension: 1–3
r Stitch length: Any
t Stitch width: Adjust as necessary
y Feed dog: Dropped