62
1. Draw both threads from the spools and pass them through
the points from z to n .
Make sure not to tangle the two strings of thread.
q Presser foot lifter
2. The threading paths from z to v are the same as single
needle.
3. Slip one of the threads into the needle bar thread guide on
the left, and the other on the right.
w Thread guide
4. Thread the needles from front to back.
* When changing the sewing direction, raise the needles
and turn the fabric.
Twin Needle Sewing (Except Model 2041S)
q Pattern selector: D, G (Models 2041SX, 2041NX)
D–L (Models 2049SX, 2049LX)
w Presser foot: Zigzag foot
e Thread tension: 1–4
r Stitch length: 0.5–1 (Satin stitch patterns)
S.S. (Stretch stitch patterns)
t Stitch width: 3
Cautions :
* Turn off the power switch before changing the needle.
* When sewing with the twin needle, test the stitches on a
scrap fabric before sewing on the actual fabrics.
* Do not set the stitch width at more than 3, or the needle
will hit the needle plate and the needle will break.
2
1
0
4
3
3
4
5
2
1
0
D
G
IJKL
IJKL
A
C
D
E
F
G
H
I
J
K
L
1
2
4 5
1
2
3
4
5
6
2
1
3
To Next Page
Loading...
