Janome 2212 - Power Connection and Foot Control

www.toews.com
8
Connecting the Machine to the Power Supply
Before connecting the power cord, make sure the voltage and
frequency shown on the machine conform to your electrical
power.
1. Turn off the power switch.
2. Insert the machine plug into the machine socket.
3. Insert the power supply plug into the outlet .
4. Turn on the power switch to turn on the power and sewing
light.
Foot control
Sewing speed can be varied by the foot control.
The harder you press on the control, the faster the machine
runs.
1
Power supply plug Power switch
Outlet Machine socket
Machine plug Foot control
2
3
4
5 6
Caution:
Do not place anything on the foot control, otherwise
the machine may start inadvertently.
1
2
3
4
5
6
Operating Instructions (for USA and Canada only):
The symbol "O" of a switch indicates the "off" position of
the switch.
For an appliance with a polarized plug (one blade wider
than the other):
To reduce the risk of electrical shock, this plug is
intended to fit in a polarized outlet only one way.
If it does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician to install
the proper outlet. Do not modify the plug in any way.
The foot controller Model YC-482J-1 or TJC-150 is used
with this sewing machine.
Janome 2212 Instruction Manual
www.toews.com
2212 Owners Manual/ User Guide