9
MECHANICAL ADJUSTMENT
PRESSER BAR HEIGHT AND ALIGNMENT
TO CHECK:
1. RAISE THE PRESSER FOOT LEVER (A).
2. THE DISTANCE BETWEEN THE PRESSER FOOT (C) AND THE NEEDLE PLATE (D)
SHOULD BE 6.0 MM (0.24").
ADJUSTMENT PROCEDURE:
1. REMOVE THE FACE COVER (SEE PAGE 4).
2. RAISE THE PRESSER FOOT LEVER AND LOOSEN THE SCREW (B) ON THE PRESSER
BAR HOLDER.
ADJUST THE DISTANCE BETWEEN THE ZIGZAG FOOT (C) AND THE NEEDLE PLATE
(D) TO 6.0 MM (0.24").
3. TIGHTEN THE SCREW (B) SECURELY.
4. ATTACH THE FACE COVER.
NOTE: WHEN YOU TIGHTEN THE SCREW (B), MAKE SURE THAT BOTH SIDES OF THE
PRESSER FOOT ARE PARALLEL TO THE FEED DOG SLOTS (E) ON THE
NEEDLE PLATE.
(A)
(B)
(E)
(D)
ZIGZAG FOOT (C)
6.0MM
To Next Page
Loading...
