Janome 659 - Zero Feeding; Zero Feeding Adjustment

ZERO FEEDINGZERO FEEDING
ZERO FEEDINGZERO FEEDING
ZERO FEEDING
TO CHECK:
1. Set the pattern selector dial at straight stitch (stitch No. 2) and the stitch length dial (D) at
“0”.
2. Place a piece of paper under the presser foot and lower the foot.
3. Check if the paper moves
forward or backward when you turn the hand wheel toward you.
4. The machine should not feed a piece of paper with the above setting.
Adjustment procedure:
1. Remove the belt cover (See page 3).
2. Set the pattern selector dial at straight stitch (stitch No. 2) and the stitch length dial (D) at
“0”.
3. Place a piece of paper under the presser foot and lower the foot. Then turn the hand wheel
toward you by hand.
4. If the paper moves forward(E). Turn the adjusting screw (C) in the direction of (A).
If the paper moves backward (F), turn the adjusting screw (C) in the direction of (B).
5. Attach the belt cover.
19