Janome 8048 - Getting Ready to Sew: Initial Setup; Connecting the Power Supply; Controlling Sewing Speed; Polarized Plug Safety

8
SECTION 2. GETTING READY TO SEW
Connecting the Power Supply
1. Turn the power switch OFF.
2. Insert the foot control jack into the machine socket.
3. Insert the machine plug into the machine socket.
4. Insert the power supply plug into the outlet.
5. Turn the power switch ON.
6. The LED display will show “01” (straight stitch)
after one second.
q Power switch
w Controll plug
e Machine socket
r Machine plug
t Power supply plug
y Outlet
Controlling Sewing Speed
Foot Controller Model 21249 is used with Sewing
Machine Model 8048.
Sewing speed is varied by the foot control.
The harder you depress the foot control, the faster the
machine runs.
CAUTION:
Do not place anything on the foot control when the
machine is not in use.
q
w
e
r
t
y
Polarized Plug
This appliance has a polarized plug (one blade wider
than the other). To reduce the risk of an electric
shock, this plug is intended to fit in a polarized outlet
only one way. If the plug does not fit in the outlet,
reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. Do not
modify the plug in any way.