31
Changing sewing direction:
Stop the machine a few stitches before the end of a seam.
Press the up/down needle button a few times until the
needle falls on the end of the seam.
Raise the presser foot.
Pivot the fabric around the needle to change the sewing
direction as desired.
Lower the presser foot and start sewing in a new direction.
1 A few stitch before the end of seam
2 End of seam
3 Changing direction
* Patterns D3, D4 (mode1), D03, D04 (mode 2) will
stop automatically after pressing the reverse button.
Using the cloth guide:
Attach the cloth guide on the needle plate with a screw.
Adjust the position of the cloth guide and tighten the screw.
Place the fabric with its edge against the cloth guide and
sew.
1 Threaded Hole
2 Cloth Guide
3 Screw
Using the seam guide lines:
The seam guides on the needle plate and hook cover help
you to measure seam allowance.
NOTE:
The numbers on the needle plate indicate the distance
from the center needle position in millimeters and inches.
1 Center Needle Position
2 Edge of the Fabric
3 Guide Lines
1
2
3
1
2
3
1
2
3
Janome 6600 Instruction Manual
MC6600P Owners Manual/ User Guide
To Next Page
Loading...
