60
Darning
Machine Settings
Pattern: 21 (Mode 3)
Thread tension: 3-6
Presser foot: Automatic Buttonhole foot R
Foot pressure: 3
The LCD screen shows the sewing instructions when
selecting patteren 21.
Pull the button holder to the rear.
Place the garment under the foot.
Press the up/down needle button twice. Remove the fabric
to the left to draw both threads under the foot and place
the fabric back under the foot.
Lower the needle at the starting point then lower the foot.
1 Button Holder
2 Starting Point
Depress the foot control and the machine will sew a
darning 2 cm (3/4”) long and stop automatically.
Repeat sewing in the different direction until the darning
covers the rip or hole.
NOTE:
The maximum size of darning is 2 cm (3/4”) long and 0.7
cm (1/4”) wide.
3Maximum Length 2 cm (3/4”)
4 Maximum Width 0.7 cm (1/4”)
1
2
3
2
4
Janome 6600 Instruction Manual
MC6600P Owners Manual/ User Guide
To Next Page
Loading...
