22
Inserting the bobbin
zPlace the bobbin in the bobbin holder with the
thread running off counterclockwise.
q Thread
w Bobbin holder
xGuide the thread into the notch on the front of the
bobbin holder.
e Notch on the front
cDraw the thread to the left, sliding it between
the tension spring blades.
r Spring blades
vContinue to draw the thread lightly until the thread
slips into the notch on the side.
t Notch on the side
bPull out about 10 cm (4˝) of thread to the rear.
Reattach the hook cover plate.
NOTE:
A threading chart is shown on the hook cover plate
for your reference.
y Threading chart
zz
zz
z
xx
xx
x
cc
cc
c
vv
vv
v
bb
bb
b
q
w
e
t
r
t
y
To Next Page
Loading...
