22
Sewing Buttons
Tape the button over the placement mark.
A pin can be placed on top of the foot to from a shank.
Before lowering the foot, test the needle swing making
sure the needle drops in each hole.
Adjust the stitch width if necessary.
Lower the foot.
Align the both holes of button with the needle swing,
lower the foot and depress the foot control.
To strengthen the shank, cut the threads leaving a 20
cm (8˝) tail.
Bring the needle thread down through the hole in the
button and wind it around the shank.
Draw the thread to the wrong side of fabric and knot.
*When button sewing is nished, return the drop feed
lever.
To Next Page
Loading...
